Double Quaker City Grinding Mill
The above illustration shows our smallest size No. D 10 & 11.
Grinds Corn and Cobs. Feed and Table Meal.
Rigged up with two hoppers; two sets of grinders in One mill.
Double Reduction Grinding Discs.
All products being ground on these mills must pass through two mills or two pairs of
plates before leaving mill; first pair of plates prepares product; second pair finishes it.
Without extra cost we furnish tight pulley adapted for any kind of power or speed.

    For Net Prices, Terms and Guarantee See Order Blank Enclosed,

No. D 10 & 11. 

No. E 13 & 14.

Power required-----------------------6 to 12 H. P.
Speed--------------- 200 to 600 revs. per minute
Capacity--------------10 to 30 bushels per hour
Size of grinding plates--------------------------- 9"
Dim. of hopper----15" long. 13" wide. 10" deep
Dim. of hopper throat------------9" long 5" wide
Size of shaft -------------------------1 7/16'" X 50"
Discharge spout from floor -------------------21"
Weight of Mill ------------------------------550 lbs.
Pulley (standard) ------------------------14" X  6"
Length of Mill------------------------------------ 51"
Width of Mill------------------------------------ 24"
Height of Mill------------------------------------42" 		Power required---------------------- 10 to 20 H. P.
Speed--------------- 200 to 600 revs. per minute
Capacity--------------15 to 50 bushels per hour
Size of grinding plates------------------------- 12"
Dim. of hopper----18" long. 18" wide. 14" deep
Dim. of hopper throat----------12" long 5" wide
Size of shaft ------------------------1 15/16'" X 62"
Discharge spout from floor -------------------24"
Weight of Mill ------------------------------900 lbs.
Pulley (standard) ------------------------18" X  8"
Length of Mill------------------------------------ 62"
Width of Mill------------------------------------- 28"
Height of Mill-------------------------------------49"

As this is the only mill which grinds the same feed through two mills on the same spindle, where the grinding pressures balance each other, it surely creates a new class of its own. The grain passes through the first mill into a screw conveyor which carries it into the back mill, where it is ground the second time, then discharges on to the floor or into the elevating bagger.
A center partition divides the two grinding cases. The tramming ring and all parts of the first mill are the same as in our single mills.