Quaker City Grinding Mill
This Style Built in 2 Sizes
With Double Reduction Grinding Discs.
The above illustration shows our smaller size No. A 10.
For Net Prices, Terms and Guarantee See Order Blank Enclosed.
No. A 10.                                        No. B 13.
Power required .............................2 to 8 H. P.
Speed ............. ....200 to 600 rev. per minute.
Capacity...................... 5 to 25 bus. per hour. 
Size of grinding plates..................................9 
Dim. of hopper..l5" long, 13" wide, 10" deep 
Size of shaft,................................1 7/16" x 34"  
Discharge spout from floor ......................13"
Weight of mill......................................350 lbs.
Pulley.................................(standard) 14" x 5" 		Power required ............................ 8 to 15 H. P. 
Speed   ..................200 to 600 rev. per minute.
Capacity................ 15 to 50 bushels per hour.
Size of grinding plates..................................12
Dim. of hopper..17" long. 17" wide. 12" deep
Size of shaft ...............................1 15/16". x 40"
Discharge spout from floor ........................17"
Weight of mill.,.....................................600 lbs.
Pulley.................................. (standard) 16" x 6"
       WITHOUT EXTRA COST we furnish suitable tight pulleys adapted for any kind of power or speed.
       Always have the lower side of belt the pulling one and the mill from 12 to 20 feet from the driving pulley. The lowest number of revolutions which will take in the quantity requires the least power.
       We call your special attention to the UNUSUALLY HEAVY SHAFTS (to prevent springing), and the LARGE DIAMETER OF GRINDING PLATES (to increase capacity) used on these mills. When selecting a mill, compare these points with other makes. The A-10 Mill can be operated with 2 H. P., either tread, gas, gasoline or wind power, but not anywhere near to its full capacity. When shipping this mill to be operated with light power (say 2 to 4 horse), we can rig it with a fly-wheel pulley, 24" x 3", instead of an ordinary fly wheel, which,